I mentioned in an earlier post that I had reservations about buying a book written by an author who describes himself as “one of the most respected professional wheelbuilders.” I went ahead anyway, downloading the £9 PDF version of “The Professional Guide to Wheelbuilding” by Roger Musson. And despite the confident-verging-on-arrogant tone in some places, this is a superb book for the novice wheelbuilder (i.e. me) and probably a very useful one for those more experienced in the craft.
Roger Musson doesn’t just describe how to build wheels but also gives detailed instruction for making most of the tools that you need for the task. I’m not sure I would have built his wheel truing stand. The potential for swearing due to my limited DIY skills probably made purchasing a ready-made one the right decision. But I would have made the dishing tool (saving £40) – that looks very simple, and I did make a rather simpler version of the nipple driver described in the book.
This really is a detailed guide that takes you through the process from start to finish. If you have computer or iPad, I’d recommend the PDF version over the printed page. The PDF is quite high resolution, which means that you can zoom into the diagrams without losing details – something that very useful in some places. If you prefer paper, you can always print the pages that are most useful. The book is not only supremely practical, it also does into the theory of calculating spoke lengths and the author has a very good, simple tool for this on his web site. Amongst the very useful tips is to measure everything and not take the manufacturer’s data, or any other published information, as being accurate when you start to build a wheel. As I built my first wheel this weekend, that advice was invaluable. Highly recommended.